COOLMOON CM-LS40 5V ARGB PC Case LED Light Bar SATA 3PIN Desktop Computer Lamp Strip 40cm Motherboard RGB Decoration Accessory
Perfect atmosphere light bar can improve image clarity and alleviate eye fatigue. Bring home theater like enjoyment, very suitable for DIY.
5V ARGB interface. Plug in the main board 5V 3-pin a RGB interface and 5V ARGB AURASYNC. It supports the connection of addressable 5V ARGB mainboards such as for ASUS, for MSI, for Gigabyte and for ASRock, realizes the software control of lighting on the mainboard, and can be programmed to customize 16 million colors (if the mainboard supports ARGB second-generation interface)
Magnetic suction installation. Convenient, practical and beautiful, it can be firmly adsorbed on the iron plate of the chassis, which is very convenient
500mm sufficient wire length. Sufficient power supply line length to meet the wiring requirements of large, medium and small chassis
Introduction of controller:
If the buyer’s motherboard does not support 5V ARGB, this controller can be used to realize dimming. It does not need motherboard support. It only needs to connect the computer power SATA interface. Through the built-in lighting mode of the controller, the lighting control of 5V 3-pin ARGB products can be realized. Multiple 5V ARGB products can be inserted at the end after being connected in series to realize the lighting control of multiple 5V ARGB products
Note: this controller does not support connecting the motherboard software to control the light synchronization; This controller is not a general controller and only supports the use of products of this brand. If it is inserted into the product line sequence of other brands, it will burn out!
Lamp strip model: CM-LS40
Light strip material: ABS + magnet
Number of lamp beads: 24
Light bar interface type: 5V ARGB
Controller interface type: SATA, 3pin
Controller wire length: 3pin: 160 (±10) mm/6.3(±0.39)in; SATA;500(±10)mm/19.7(±0.39)in
Length of light strip: About 500mm/19.7in
Lamp strip size: 400 * 10 * 3mm/15.7×0.39×0.12in
Light strip weight: 20g
Controller weight: 20g
Controller size: 46x22x9.5mm/1.8×0.87×0.37in
Click M to switch to the next lighting mode, which can cycle to switch the controller’s own lighting mode; Click S to switch the light change speed. There are 8 gears that can be switched circularly; Long press the S key for 4 seconds to turn off the light, and then long press for 4 seconds to turn on the light; Click the C key to switch to other light colors under the same pattern or the light is reversed. Long press the C key for 5 seconds to switch the light brightness. The brightness of 6 gears in total can be reduced (cycle switching).
AURASYNC of 12V 4-pin motherboard is not supported
Be sure to disconnect the power and plug the cable, otherwise the wrong interface will cause short circuit and burn the equipment!
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.